Αναγνώσιμο απόσπασμα της τεκμηρίωσης. Για όλους τους πίνακες, τις εικόνες και τις πλήρεις οδηγίες, ανοίξτε το πρωτότυπο PDF.
Σελίδα 1
Safety SubCulture Unit 2 (SCU2) Quick Guide
Insert SCU2
Remove SCU2 from Hold bottle with one hand. Hold SCU2 in place and
package and position over unscrew dispensing tip
top of disinfected bottle With other hand, press down protective cover.
septum. on SCU2 to pierce bottle
septum.
Dispense Drops
Tilt bottle downward at Dispense drops to slide and Replace protective cover
an approximate 45 degree media plates. over dispensing tip.
angle.
When finished return bottle
to upright position.
Remove and Discard SCU2
Hold bottle with one hand Discard into appropriate Note: This document is a product use reference guide.
and with other hand pull up bio-hazard container. Please consult the package insert for the complete
on SCU2 to remove. Instructions for Use.
Product Code
A100722: Sterile, 288/case, 48/box, 6 boxes/case
Product Information
Not Made with Natural Rubber Latex
Single Use Only
1.888.411.2851 sales@itlbiomedical.com itlbiomedical.com
Copyright © 2019 ITL Corporation. All rights reserved. ITL-BR-0092
Σελίδα 2
Safety SubCulture Unit 2 (SCU2) Tips & Tricks
Follow your institution’s policies & procedures
General Guidelines
SCU2 may not sit flush on Hold SCU2 in place when Tilt bottle to smaller angle
top of bottles that have a unscrewing the protective (approximately 30 - 45
smaller diameter than the cover over dispensing tip. degrees) for better control of
cap. drop size and speed.
This does not interfere with
dispensing drops.
If sample drops are slow When dispensing to a series Gaseous samples tend to
to dispense, give the bottle of slides and media plates, flow more quickly.
a gentle shake to start the dispense drops sequentially
flow of drops. without fully uprighting the Tilt bottle upward to reduce
bottle between drops. drop size and rate flow.
If sample drops slow during
dispensing, rock bottle
back and forth to resume
dispensing drops.
Bottles with Resins or Beads
Prior to dispensing drops, Now, increase the angle If resins or beads obstruct
reduce potential clogging of the bottle tilt to the flow of sample
by tilting the bottle to a approximately 30 - 45 drops, upright bottle.
horizontal position allowing degrees to begin dispensing Place protective cap over
resin or beads to settle drops. dispensing tip and gently tap
along the side of the bottle bottom of bottle on counter
away from the piercing tip. to clear the resins or beads.
Remove c
Σελίδα 2
away from the piercing tip. to clear the resins or beads.
Remove cap, re-position
bottle and resume dispensing
drops.
Flexible Fit
1.888.411.2851 sales@itlbiomedical.com itlbiomedical.com
Copyright © 2019 ITL Corporation. All rights reserved. ITL-BR-0092